Default Settings After Initial Switch Configuration - Cisco Catalyst 2960 Software Configuration Manual

Chapter 1 Overview

Default Settings After Initial Switch Configuration

The switch is designed for plug-and-play operation, requiring only that you assign basic IP information
to the switch and connect it to the other devices in your network. If you have specific network needs,
you can change the interface-specific and system- and stack-wide settings.
For information about assigning an IP address by using the browser-based Express Setup program, see
Note
the getting started guide. For information about assigning an IP address by using the CLI-based setup
program, see the hardware installation guide.
If you do not configure the switch at all, the switch operates with these default settings:
•
•
•
•
•
•
•
•
•
•
•
•
•
•
OL-26520-01
Default switch IP address, subnet mask, and default gateway is 0.0.0.0. For more information, see
Chapter 3, "Assigning the Switch IP Address and Default Gateway,"
DHCP and IP Source Guard Features."
Default domain name is not configured. For more information, see
IP Address and Default Gateway."
DHCP client is enabled, the DHCP server is enabled (only if the device acting as a DHCP server is
configured and is enabled), and the DHCP relay agent is enabled (only if the device is acting as a
DHCP relay agent is configured and is enabled). For more information, see
the Switch IP Address and Default Gateway,"
Guard Features."
Switch stack is enabled (not configurable). For more information, see
Stacks."
Switch cluster is disabled. For more information about switch clusters, see
Switches," and the Getting Started with Cisco Network Assistant, available on Cisco.com.
No passwords are defined. For more information, see
System name and prompt is Switch. For more information, see
Switch."
NTP is enabled. For more information, see
DNS is enabled. For more information, see
TACACS+ is disabled. For more information, see
Authentication."
RADIUS is disabled. For more information, see
Authentication."
The standard HTTP server and Secure Socket Layer (SSL) HTTPS server are both enabled. For more
information, see Chapter 9, "Configuring Switch-Based Authentication."
IEEE 802.1x is disabled. For more information, see
Port-Based Authentication."
Port parameters
Interface speed and duplex mode is autonegotiate. For more information, see
–
Auto-MDIX is enabled. For more information, see
–
Flow control is off. For more information, see
–
PoE is autonegotiate. For more information, see
–
Catalyst 2960 and 2960-S Switches Software Configuration Guide, Release 15.0(1)SE
Default Settings After Initial Switch Configuration
and
Chapter 3, "Assigning the Switch
and Chapter 20, "Configuring DHCP and IP Source
Chapter 7, "Managing Switch
Chapter 5, "Administering the Switch."
Chapter 5, "Administering the
Chapter 5, "Administering the Switch."
Chapter 5, "Administering the Switch."
Chapter 9, "Configuring Switch-Based
Chapter 9, "Configuring Switch-Based
Chapter 10, "Configuring IEEE 802.1x
Chapter 20, "Configuring
Chapter 3, "Assigning
Chapter 6, "Clustering
1-17