Editing An Automation List - Lexicon NUVERB - FOR MACINTOSH Manual

Learning to Use NuVerb

Editing an Automation List

Let's go ahead and do some editing on the list you made in the previous section.
• Open your list. To do this, select Open from the File menu. Among the listings, you should
see the list we just created. When you select it, it will open in the smaller "Monitor" view.
• Click on any program to select it.
• Copy , then Paste using the standard Macintosh techniques.
• Enter the time code location where you want this program to start, then click OK. A copy
of the program will be pasted into the list at the time code location you have selected.
(Using Cut and Paste is identical, except that the original you select is removed from the list
and pasted into the new location.)
Trimming
Hold option and click on the start time or duration value field. Typed in values are entered
from right to left.
To select either the start time or the duration of list entries, hold option while clicking on the
number. Once the number is selected, just type in the amount you want to change. For
example, if the start time is 01:00:12:26, and you want to make it 10 frames earlier, you only
have to type "10" (the number of frames), not the whole number.
If you want to type in a new location that is less than the current location you must type a
complete timecode entry, including any leading zeros. This is also true for entering offsets.
Hold option and click on the start-
ing time to select the field.
52
52
Lexicon
Type in a new timecode entry.
Digits will be entered from right to
left.