Lexicon NUVERB - FOR MACINTOSH Manual page 98

Reference
L TRB+ (Left Treble Adjust), RTRB+ (Right TrebleAdjust)
These controls allow independent adjustment of left and right treble. They may be used
together with the stereo adjustments to create a 12 dB/octave cut or boost. Note that the 3 dB
frequencies can be different from the stereo set.
Stereo Adjustments
MSTR (Master Level)
MSTR is a stereo level control, with both channels equally attenuated or boosted. From -12 to
+12 the fader moves in .25 dB increments. Below -12 it moves in .50 dB increments. Below -60
dB the calibration comes in larger steps, finally dropping to zero output at -72 dB.
11µs (1/2 Sample)On/Off
When this control is on, the left channel is delayed relative to the right by 11µsec (1/2 sample).
This control specifically corrects for the timing error between channels caused by consumer
digital systems (e.g. the Sony PCM-F1 and its progeny) that time-share single analog convert-
ers. Turning on this delay time aligns the left channel audio data for compatibility with
professional systems.
R F'n'S (Right Channel Flip 'n' Swap)
RFnS is used for digitally correcting problems you used to be able to fix (or create) by switching
analog cables around. The normal setting is +L to the left output and +R to the right output.
Other settings should only be used when correcting some problem created previously in the
recording process.
+L+R = Normal Routing
+L-R = Right Channel polarity inverted (flipped)
+R+L = Left and Right Channels swapped
-R+L = Right flipped and swapped with Left
BAL (Balance)
BAL implements a sine/cosine balance adjustment. Balance is smoothly adjusted over a wide
range, with excellent resolution in the critical area around zero. The display indicates the actual
channel gains as the control is varied.
92
92
Off, -72 - +12dB
+L-R, +L-R+R+L, -R+L
L+2.9dB- R+2.9dB
Lexicon
Cut, -18 - +6dB