Lexicon NUVERB - FOR MACINTOSH Manual page 13

NuVerb User Guide
6. Remove the NuVerb Effects Card from its static-proof bag.
Hold the card by its top edge. Avoid touching the connector on the bottom of the card. If
you lay the card down, make sure to place it on its static-proof bag.
7. Align the card over the Expansion slot.
You may have to push the card toward the back of the computer chassis to do this, as there
are small, spring-loaded metal tabs on the slots.
8. Press down firmly on the card until the connector is seated.
Don't force the card. If you meet a lot of resistance, pull the card out, and inspect the
connector to make sure that none of the pins are bent. Try seating the card again.
To see if the card is properly connected, lift it gently. If it resists and stays in place, it's
connected.
9. Replace the cover on the computer.
Refer to the instructions provided with your particular Macintosh model. Do not operate
the system without the cover.
Hold the card by its upper edge.
Once the card is aligned, press firmly to
seat the card into the connector.
Getting Started
7
7