Working With Midi - Lexicon NUVERB - FOR MACINTOSH Manual

Learning to Use NuVerb

Working with MIDI

Select a MIDI Driver
MIDI drivers are selected under Preferences in the Edit menu. Select Apple MIDI
Manager, Opcode OMS, or both.
In order to work with MIDI, you must first enable MIDI Manager and/or OMS. Select
Preferences from the Edit menu and make your selection. Once you have made your sleection
and clicked OK, you will be instructed to re-start NuVerb. Click OK, quit, and restart NuVerb.
Note:
If both MIDI Manager and OMS are used, you will want to use two MIDI interfaces — one for each driver.
Each interface will require the use of one Macintosh serial port (printer or modem). Refer to the
manufacturer's instructions included with the interface.
The MIDI Setup Window
Once you have rebooted NuVerb with your MIDI driver selections, the MIDI menu items
under Options — MIDI Setup ... (Command M) and Open MIDI Input Window (Command
I) will be enabled.
Open MIDI Input Window (Command I) opens a status window where you can verify the
current status of your MIDI configuration.
MIDI Setup ... (Command M) opens the MIDI Setup window shown on the previous page.
Open the MIDI Setup window.
38
38
Lexicon