Appendix - Lexicon NUVERB - FOR MACINTOSH Manual

NuVerb User Guide
Hardware Verification
Check off these items:
Card correctly seated in NuBus socket with no bent pins
Digidesign Expansion chassis correctly installed and functioning properly (if applicable)
Audio source has AES output capability
NuVerb AES I/O cable correctly connected to AES source/destination
Audio monitoring device correctly connected to receive NuVerb output.
NuVerb passes audio
Check to make sure the board is passing audio
The NuVerb board should pass audio as soon as the Mac is powered up. By connecting any
AES signal source and monitoring the output, you can verify that the board is receiving power
and that the AES I/O is OK. This can be done without installing or running the software
application.
Note: To connect an analog source to NuVerb, an external A/D-D/A converter with AES I/O will be
required. If you are installing NuVerb with a digital source that uses a format other than AES,
a format converter will be required.

Appendix

4
Appendix
Troubleshooting
A-1
1