Editing Programs; Program Parameters - Lexicon MPX 200 - REV 2 Manual

Basic Operation

EDITING PROGRAMS

The Adjust knob is used to control edit functions. The
EDIT LEDs indicate the selected parameter, while the
display indicates that parameter's setting.
1. Press the Edit button to enter Edit Mode.
Each time the Edit button is pressed, the
unit selects the next parameter.
2. Turn the Adjust knob to change the parameter
setting. An appropriate value for that parameter will
be displayed.
After a parameter setting is changed, the MPX 200
will wait 4-seconds, then "timeout" and revert to
displaying the active program number on the
display. Edit Mode is still active as long as the current
parameter LED is lit.
2-4
The System Mode parameters Global Compressor Mode,
Global Mix Mode, and Global Tempo Mode (Tap) can be
set to either Global (Glo) or Program (Pro). When set to
Program, a change to these parameters is considered a
program edit and is reported with the activation of the
Edit LED. When set to Global, a change is not
considered an edit.
If Load is pressed prior to changing a parameter setting,
pressing Edit will return to the previous parameter. The
Edit button lights when a parameter setting has been
changed and differs from the stored setting.
Press the Load button to reassign the Adjust knob to
select Programs.

PROGRAM PARAMETERS

Mix
Controls the proportion of processed (wet) to
unprocessed (dry) signals. Settings range from Dry to
100% (Wet).
Lexicon
(Dry, 1 to 100%)