Lexicon NUVERB - FOR MACINTOSH Manual page 96

Reference
Stereo Adjust
General Description
The Stereo Adjust effect offers fine adjustments of level and equalization during digital
mastering. Its stereo digital fader permits 0.25dB trimming and provides full fades to digital
zero at the end of a track. Its two sets of shelving treble EQ can be set for different 3dB points
and gains. BASS and SPEQ permit adjustment of stereo width, enhancing the spaciousness and
depth of the recording.
Stereo Adjust Parameters
The Equalizer
BXVR (Bass Crossover)
BXVR sets the crossover point for BASS and SPEQ. When BASS is set to full cut, the level is -
3 dB at the frequency set with BXOV.
BASS+ (Bass EQ)Cut, -18dB - +12dB
BASS is a 6dB/octave shelving EQ control with a range of +6 dB boost and -18dB cut. It moves
in .50 dB steps from +6 to -6 dB. The crossover point is adjusted with BXVR. BASS acts on both
stereo channels equally.
SPEQ (Spatial EQ)
SPEQ sets the amount of a crossfeed between channels. The signal first goes through a 6 dB/
octave low-pass filter whose frequency is set with BXVR.
When SPEQ is set positive (above 0) the crossfeed has a negative sign. When SPEQ is set
negative (below 0), the crossfeed has a positive sign. When the control is set to either maximum
or minimum, the gain in the crossfeed circuit is unity.
The result of this control is to change the separation of low frequency stereo signals. When the
control is raised, low frequencies in the sum (mono) channel are reduced, and low frequencies
in the difference (stereo) channel are raised. With the control at maximum, low frequency
90
90
0.1 - 26.5kHz
Cut, -6 - +6dB
Lexicon