Camber Mix; Multi Engine - FUTABA 12Z Series Instruction Manual

RUD to AIL
This mix is used to correct roll maneuvers,
knife edge, etc. of stunt planes. [Airplane/glider,
general]

CAMBER Mix

This mix adjusts the camber and corrects the
elevators. [Airplane/glider, 2 ailerons or more]
ELE to CAMBER
This mix is used when you want to the mix camber
be increased at elevators up. [Airplane/glider, 2
ailerons or more]
CAMBERFLP to ELE
This mix is used to correct for attitude changes when
BUTTERFLY (Crow)
This function is used when powerful brake operation
is necessary. [Glider, 2 ailerons or more]
TRIM MIX 1/2
be called by switch or condition selection. [Glider, 2
ailerons or more]
AIRBRAKE
This function is used when airbrakes are necessary
(Airplane, general)
GYRO
used. [Airplane/glider, general]
RUDDER 1
Winglet
( )
at Flying wing
AIL 3
(Chip Aileron)
ELEVATOR
(RUDDER 2)
AIL1 FLP 3
(Brake Flap)
(Main Aileron) (Brake Flap)
FLP 1
(Camber Flap)
V-TAIL
RUDDER ELEVATOR
(ELEVATOR 2)
(AILERON 5)
V-TAIL
This function adjusts the elevators and rudder of
AILEVATOR
This function adjusts the elevators and ailerons of
WINGLET
This function adjusts the left and right rudders
of winglet models. [Airplane/glider, winglet
MOTOR
The operation speed when the motor of F5B and
other EP gliders is started by switch can be set. [EP
glider, general]
RUD to ELE
This function is used to correct roll maneuvers, knife
edge, etc. of stunt planes. [Airplane, general]
SNAP ROLL
This function selects the snap roll switch and adjusts
also be adjusted. [Airplane general]

MULTI ENGINE

This function adjusts the throttles independently
when using a multi engine model. (Maximum 4
engines) [Airplane, general]
AIR BRAKE
FLP 4
RUDDER 2
AIL 2
(Main Aileron)
(
at Flying wing
AIL 4
FLP 2
(Camber Flap) (Chip Aileron)
AILVATOR
ELEVATOR 2
(AILERON 6)
<Model Menu (Airplane/Glider Functions)>
Winglet
)
79