Setting method
independently.
Curve setting examples
The screens shown below are curves created by
entering the pitch rate at low, center, and high side
3 points or 5 points at each condition. They were
created by reducing the number of points to the
3 points of low side, center, and high side. When
Normal Curve
Pitch Trim (Hovering pitch, high pitch, low pitch)
The hovering pitch, low pitch, and high pitch trim setup screen can be called from the PIT Curve setup
screen.
108
<Functions of Model Menu (Helicopter Functions)>
the fuselage (or the reference value).
*For a description of the curve setting method, see the
Idle-up 1 Curve
Idle-up 2 Curve
enter a point and push the enter button. The point
is created.
description at the back of this manual.
Hold Curve
(Continued on next page)