FUTABA 12Z Series Instruction Manual page 121

Operations related to servo speed
Servo speed setting (1)
The servo speed at each function operation
(including flight condition switching) can be
adjusted. The servos operate smoothly at a
operating speed (IN side) and return speed (OUT
side) can be set individually.
Switch the operation mode according to the
set function.
"SYMMET" mode: Mode used with ailerons
and other self neutral functions.
"LINEAR" mode: Mode used with functions
which hold the operation position of the
throttle and switch channel, etc.
[Setting method]
1. Use the cursor lever to move the cursor
(reverse-video) to the [MODE] item.
2. Turn the data input dial to the left or
right and switch to the operation mode
("SYMMET" or "LINEAR") corresponding to
the set function.
3. Move the cursor to the direction ([IN] or
[OUT]) side you want to set.
4. Turn the data input dial to the left or right
and set the speed.
Initial value: 0
Adjustment range: 0~27 (maximum delay)
(When the enter button is pushed for 1 second, the servo
speed is reset to the initial value.)
Servo speed setting (2)
The operation start point at operation (IN
side) and return (OUT side) can also be set by
servo speed setting (1) function.
[Setting method]
*Perform the [SPEED] item the same as [Servo speed
setting (1)]. Set [DELAY] (operation start point) by the
following method:
1. Use the cursor lever to move the cursor
(reverse-video) to the [START] item.
2. Turn the data input dial to the left or right
and set the delay from switch ON to the
start of function operation.
Initial value: 0.0sec
Setting range: 0 to 9 sec
(When the enter button is pushed for 1 second, the servo
speed and delay are reset to the initial values.)
3. Use the cursor lever to move the cursor
(reverse-video) to the [STOP] item.
4. Turn the data input dial to the left or right
and set the delay time from switch OFF to
the start of function operation.
Initial value: 0.0 sec
Setting range: 0 to 9 sec
(When the enter button is pushed for 1 second, the servo
speed and delay are reset to the initial values.)
<Data> 121