Model Basic Setting Procedure - FUTABA 12Z Series Instruction Manual

MODEL BASIC SETTING PROCEDURE

Airplane/glider basic setting procedure
1. Model addition and call
Initial setting assigns 1 model to the T12Z
transmitter. The Model Select function of the
Linkage Menu is used to add models and to select
models which are already set.
The data for up to 25 models can be saved
to the transmitter. Data can also be saved to the
optional CF card.
The currently selected model name is displayed at
When a new model is added, the Model type select
screen and Frequency/Modulation mode/Receiver ID
setup screen automatically appear. Please be aware
that the transmitter will stop transmitting when you
change the model.
2. Model type selection
Select the model type matched to the aircraft with
the Model Type select function of the Linkage Menu.
For an airplane, select the model type from among
the 3 types: airplane, glider, and motor glider. After
the wing type is selected the Tail type select screen is
displayed. Select the tail type matched to the aircraft.
There are 13 wing types and 3 tail types for airplane,
glider, and motor glider.
3. Fuselage linkage
Connect the ailerons, elevators, throttle, rudder,
etc. in accordance with the model's instruction
manual. For a description of the connection
method, see the Receiver and Servos Connection.
Note: The channel assignment of the T12Z is different
from that of our existing systems. Note that even
for the same "airplane model", when the wing type
and tail type are different, the channel assignment
may be different. (The channel assigned to each
function can be checked at the Function menu of
the Linkage Menu.)
<Model Basic Setting Procedure> 37