FUTABA 12Z Series Instruction Manual page 60

END POINT (ATV)
The End Point function adjusts the left and right
servo throws, generates differential throws, and
will correct improper linkage settings.
The Travel rate can be varied from 30% to 140%
in each direction on channels 1 to 12. Also, the
Limit point where servo throw stops may be varied
from 0% to 155%.
[Return Key]
Servo travel adjustment
(When the enter button is pushed for 1 second, the rate is
reset to the initial value.)
Limit point adjustment
(When the enter button is pushed for 1 second, the limit point
is reset to the initial value.)
60 <Functions of Linkage Menu>
(The display screen is an example. The screen depends on the model type.)
NOTE: The Servo Speed setting is used to set the servo delay
for each channel, from channel l to channel 12. The system
uses the programmed speed (delay) to slow down servo
position changes. The Servo Speed setting can be varied
from 0 to 27 in each channel.
PUSH
Servo speed setting
(When the enter button is pushed for 1 second, the servo
speed is reset to the initial value.)
[Cursor Lever]
[Data Input Dial]
[Enter Button]