AIL to RUD
Use this mix when you want to mix the rudders
with aileron operation.
menu and call the setup screen
shown below by pushing the
enter button.
[Return Key]
switching
(For more information, refer to
the description at the back of
this manual.)
*The display screen is
an example. The actual
screen depends on the
model type.
Setting method
data input dial to the left and push the enter
(For a description of the switch selection method,
see the description at the back of this manual.
The adjustment rate and direction can be set. The
(For a description of the curve setting method, see
the description at the back of this manual.)
84
<Model Menu (Airplane/Glider Functions)>
(
(Currently selected condition name)
*For a description of the curve setting method, see the
description at the back of this manual.
turn the
[Fine tuning VR operation mode]
AIL1
AIL 2
(Main Aileron)
(Main Aileron)
AIL 3
(Chip Aileron)
(Chip Aileron)
RUDDER 1
Winglet
)
at Flying wing
V-TAIL
RUDDER 2
RUDDER
RUDDER
PUSH
and counterclockwise, the mixing
r a t e i n c r e a s e s a n d d e c r e a s e s ,
respectively.
rate increases.
rate increases.
or right of the neutral position, the
mixing rate increases.
AIL 3
RUDDER 2
Winglet
(
)
at Flying wing
[Cursor Lever]
[Data Input Dial]
[Enter Button]