FUTABA 12Z Series Instruction Manual page 55

FUNCTION
When you select model and wing (swash) types,
you will find that the optimized combinations of
servo output channels and functions have been
already preset. If you would like, you can freely
change combinations of servo output channels,
functions (aileron, elevator, etc), and input
controllers (sticks, switches, trim levers and trim
switches).
*You can also assign the same function to multiple servo
output channels such as assigning elevator function to CH2
and CH3.
[Return Key]
(The display screen is an example. The screen depends on the model type.)
Function change
*The function selection screen is displayed.
*The function name blinks.
*Multiple channels can be assigned to one function.
Operation control change
*The control selection screen is displayed.
VC1~VC4 (virtual channels)
These four channels can be set as virtual functions
that do not have servo output channels. You can
freely change combinations between functions
(aileron, elevator, etc) and input controllers (sticks,
switches, trim levers and trim switches).
Servo Output Channels
For PCMG3 mode, you can set twelve linear
channels. For PCM1024 mode, you can set eight
linear channels and one digital channel. For PPM
mode, you can set only eight linear channels.
*DG1 (switch channels)
This channel can be used as switch channels. You can freely
change combinations between servo output channels and
input controllers (sticks, switches, trim levers and trim
switches).
PUSH
*The same control can be assigned to multiple channels.
*The setting can be changed for each condition.
After the set mode is changed from group mode [GROUP]
to single mode [SINGL] at the control selection screen, only
that condition setting is changed by control change; setting
of other conditions remains the same.
<Functions of Linkage Menu>
[Cursor Lever]
[Data Input Dial]
[Enter Button]
55