Checklist for Deploying the Cisco Unified
Wireless IP Phone 7921G
The following topics provide an overview of procedures for adding Cisco Unified Wireless IP Phones
to your network:
•
•
•
•
Configuring the Wireless Network
Table D-1
Aironet Access Point, controller, and Ethernet switch.
When deploying the Cisco Unified Wireless IP Phone 7921G with World regulatory domain
Note
(CP-7921G-W-K9), you must enable the access points for world mode (802.11d). The world model
phone gets the channels and power information from the access point.
Table D-1
Wireless Network Configuration Tasks
Activity
1.
Check that the Cisco IOS
version is the
recommended version
Configure a VLAN for
2.
voice
Cisco Unified Wireless IP Phone 7921G Administration Guide for Cisco Unified Communications Manager Release 7.0
OL-15985-01
Configuring the Wireless Network, page D-1
Configuring QoS Policies, page D-3
Configuring the Cisco Unified Wireless IP Phone 7921G in Cisco Unified Communications
Manager, page D-4
Installing the Cisco Unified Wireless IP Phone 7921G, page D-7
explains and provides references for many of the configuration activities for the Cisco
Explanation
•
Under System Software, verify that Cisco
IOS version 12.3(8)JA or later is running on
the AP.
For the controller, use Version 4.0 and
•
Cisco IOS version 12.3(8)JX or later.
Isolate voice traffic and enable QoS by
configuring a separate voice VLAN on the
access point and network switch.
A P P E N D I X
Reference
Interacting with Cisco Unified Wireless
APs, page 2-9
Voice QoS in a Wireless Network,
page 2-10
Cisco IOS Software Configuration Guide
for Cisco Aironet Access Points, Cisco IOS
Release 12.3(8)JA
D
D-1