Assigning The Wavelink Avalanche Server Using The Phone Web Page; Setting Up And Using The Phone Configuration Utility; Assigning Attributes For The Phone - Cisco 7921G - Unified Wireless IP Phone VoIP Administration Manual

Chapter 6 Configuring the Phone Using the Wavelink Avalanche Server
Step 5 Enter the IP address of the Wavelink Avalanche server, and press Save.

Assigning the Wavelink Avalanche Server using the Phone Web Page

To assign the Wavelink Avalanche server using the phone web page, follow these steps:
Procedure
From the phone web page, choose Wavelink Settings from the left pane.
Step 1
Under Wavelink Settings, make sure that the server is enabled.
Click Use the following Server and enter the IP address of the server, then click Save.
Step 2

Setting Up and Using the Phone Configuration Utility

This section describes the tasks for configuring and using the Cisco Unified Wireless IP Phone 7921G
Configuration Utility from the Wavelink Avalanche Management Console.
To set up and use the Cisco Unified Wireless IP Phone 7921G Configuration Utility from the Wavelink
Management Console, perform the tasks in
Table 6-1 Setting Up and Using the Phone Configuration Utility on the Wavelink Console
Task
Assign attributes for the phone.
1.
Install the Cisco Unified Wireless IP Phone 7921G
2.
Configuration Utility on the Wavelink Avalanche
Management Console.
Update the configuration files.
3.
Update the phones.
4.

Assigning Attributes for the Phone

You can assign attributes on the Cisco Unified Wireless IP Phone 7921G that can be used to distinguish
it from other mobile devices connected to the Wavelink Avalanche server. These attributes can be used
as search criteria for locating phones on the Wavelink Avalanche server. For example, the predefined
ModelName field of CP7921G is used to identify a device as the Cisco Unified Wireless IP Phone
7921G.
To assign attributes, use the Wavelink Avalanche Management Console, the phone UI, or the phone web
page:
•
Cisco Unified Wireless IP Phone 7921G Administration Guide for Cisco Unified Communications Manager Release 7.0
OL-15985-01
If you use the Wavelink Avalanche Management Console, choose the Add Properties option from
the Client Settings option (for a single phone) or the Edit Device Properties option (for a mobile
device group).

Setting Up and Using the Phone Configuration Utility

Table 6-1.
For more information, see...
Assigning Attributes for the Phone, page 6-3
Installing the Cisco Unified Wireless IP Phone 7921G
Configuration Utility, page 6-5
Updating Configuration Files, page 6-5
Updating the Phone, page 6-11
6-3