Site Survey Utility - Cisco 7921G - Unified Wireless IP Phone VoIP Administration Manual

Site Survey Verification
Step 6 Adjust AP and antenna placement and AP power settings to provide approximately 20 percent coverage
overlap.

Site Survey Utility

The Site Survey utility is used to actively and passively scan the wireless medium across all channels
and locate APs that belong to the Basic Service Set (BSS). The results of the scans are then used help to
identify areas of low coverage, if any, and to determine whether the APs are configured consistently as
recommended in the Cisco deployment guidelines.
When you start the Site Survey utility, the phone disassociates from the current AP and remains
disassociated for the duration of the operation.
For more information, see
During Site Survey, both active and passive scans are performed at a rapid rate. These scans will result
Caution
in the phone battery life depleting faster than normal and might cause disruption to the wireless medium.
To use the Site Survey utility, follow these steps:
Procedure
Step 1 Configure the Cisco Unified Wireless IP Phone 7921G with the same SSID and
encryption/authentication settings as the APs.
Step 2 Power on the phone so that it associates with the WLAN.
Step 3 Choose Settings > Status > Site Survey.
The phone displays a list of APs within range that have the same SSID and security settings as the phone.
To see more information about an AP, scroll to the desired line and press Details.
Step 4 To verify the ability to roam between APs, walk through all areas where phones are used and take
readings. Approach areas from different directions to assure successful roaming conditions.
Step 5 Adjust AP and antenna placement and AP power settings to provide approximately 20 percent coverage
overlap.
Step 6 When you terminate the site survey, a report is generated for your viewing from the phone web page.
For more information, see
In addition to the Site Survey utility in the Cisco Unified Wireless IP Phone 7921G, you can also use the
Cisco Aironet Client Utility Site Survey Utility from a laptop PC. Refer to the section on "Performing a
Site Survey" in the
for your system.
Related Topics
•
•
Cisco Unified Wireless IP Phone 7921G Administration Guide for Cisco Unified Communications Manager Release 7.0
2-22
Viewing the Site Survey Report on the Web, page
Viewing the Site Survey Report on the Web, page
Cisco Aironet Wireless LAN Client Adapters Installation and Configuration Guide
Site Survey Verification Tasks, page 2-20
Viewing the Site Survey Report on the Web, page 4-41
Chapter 2 Overview of the VoIP Wireless Network
4-41.
4-41.
OL-15985-01