Installing the Cisco Unified Wireless IP Phone 7921G Configuration Utility
Table 6-3
Profile Settings (continued)
Item
WPA Pre-shared Key
Credentials
Pre-shared Key Type
Pre-shared Key
Wireless Encryption
WEP Keys Type
WEP Keys TxKey
WEP Key Length 1-4
WEP Key Value 1-4
Network Settings
DHCP Enabled
TFTP
Alternate TFTP
Advanced WLAN Settings
TSPEC Settings
Minimum PHY Rate
Surplus Bandwidth
Antenna Settings
Antenna Selection for
802.11A
Cisco Unified Wireless IP Phone 7921G Administration Guide for Cisco Unified Communications Manager Release 7.0
6-8
Description
Sets the Pre-shared key for this profile
Determines the key type: Hex or ASCII
Identifies the key
Required for Open+WEP and Shared+WEP authentication methods
Determines the encryption key type: Hex or ASCII
Identifies the Transmit Key.
Determines the WEP key length with key size of 40 or 128 bits.
Defines the WEP key value:
•
40 bits—5 ASCII or 10 Hex characters
•
128 bits—13 ASCII or 26 Hex characters
•
Yes—Enables DHCP to obtain IP address and DNS servers
automatically.
No—DHCP is disabled and you will need to enter the
•
following fields:
IP Address
–
–
Subnet Mask
Default Router
–
–
Primary DNS
–
Secondary DNS
–
Domain Name
Determines whether DHCP assigns the TFTP server.
If yes, enter static IP addresses for:
•
TFTP Server 1
•
TFTP Server 2
Minimum data rate that outbound traffic uses
Excess bandwidth beyond application requirements
•
Vertical
Horizontal
•
Diversity
•
Chapter 6
Configuring the Phone Using the Wavelink Avalanche Server
For More Information, See...
OL-15985-01