Cisco 7921G - Unified Wireless IP Phone VoIP Administration Manual page 62

Installing the Cisco Unified Wireless IP Phone 7921G
Figure 3-4
1
@
4
G H I
7
P Q R S
*
1
2
3
Note
To turn off the Found New Hardware Wizard when using the USB cable to charge the phone, follow
these steps:
Procedure
Step 1 Plug the USB cable into the Cisco Unified Wireless IP Phone 7921G.
Step 2 Plug the USB connector into the USB port on your PC.
The Found New Hardware Wizard dialog opens.
Step 3 To turn off the wizard, for Update New Software, click No, not this time.
Step 4 Next, click the button next to Install the Software automatically (Recommended).
Step 5 After a time delay, the Cannot Install This Hardware dialog box appears. Click Don't prompt me again
to install this software.
Step 6 Click Finish to close the dialog box.
The phone briefly displays "USB Connected" on the status line.
Cisco Unified Wireless IP Phone 7921G Administration Guide for Cisco Unified Communications Manager Release 7.0
3-12
Charging the Phone Using a USB Cable Connected to a PC
3
D E F
3
2
ABC
M N O
6
5
JKL
Z
9 W X Y
8
TUV
#
0
1
Phone connection—Insert into slot at bottom of phone.
USB connector—Insert into USB port on PC.
Indicator LED—Indicates the charging status.
When you plug the phone into the USB port, the Found New Hardware Wizard appears. Use the
following steps to avoid this pop-up window every time you use the USB cable with your phone.
Chapter 3
2
Setting Up the Cisco Unified Wireless IP Phone 7921G
OL-15985-01