Appendix G Command Interpreter; Accessing The Cli; Command Syntax; Command Usage - ZyXEL Communications P-660HW-T - V2 User Manual

The following describes how to use the command interpreter. You can telnet to access the CLI
(Command Line Interface) on the ZyXEL Device. See the included disk or zyxel.com for
more detailed information on these commands.
Note: Use of undocumented commands or misconfiguration can damage the unit and
possibly render it unusable.

Accessing the CLI

Use the following steps to telnet into your ZyXEL Device.
1 Connect your computer to the ETHERNET port on the ZyXEL Device.
2 Make sure your computer IP address and the ZyXEL Device IP address are on the same
subnet. In Windows, click Start (usually in the bottom left corner), Run and then type
telnet 192.168.1.1
3 A login screen displays. Enter the default admin password "1234".

Command Syntax

• The command keywords are in courier new font.
• Enter the command keywords exactly as shown, do not abbreviate.
• The required fields in a command are enclosed in angle brackets <>.
• The optional fields in a command are enclosed in square brackets [].
• The |symbol means or.
For example,
sys filter netbios config <type> <on|off>
means that you must specify the type of netbios filter and whether to turn it on or off.

Command Usage

A list of valid commands can be found by typing help or? at the command prompt. Always
type the full command. Type exit to log out of the CLI when finished.

Appendix G Command Interpreter

A
P P E N D I X
Command Interpreter
(the default ZyXEL Device IP address) and click OK.
P-660HW-T v2 User's Guide
G
305