Table 101 Ike Logs - ZyXEL Communications P-660HW-T - V2 User Manual

P-660HW-T v2 User's Guide

Table 101 IKE Logs

LOG MESSAGE
Active connection allowed
exceeded
Start Phase 2: Quick Mode
Verifying Remote ID failed:
Verifying Local ID failed:
IKE Packet Retransmit
Failed to send IKE Packet
Too many errors! Deleting SA
Phase 1 IKE SA process done
Duplicate requests with the
same cookie
IKE Negotiation is in process The router has already started negotiating with the peer for
No proposal chosen
Local / remote IPs of
incoming request conflict
with rule <%d>
Cannot resolve Secure Gateway
Addr for rule <%d>
Peer ID: <peer id> <My remote
type> -<My local type>
vs. My Remote <My remote> -
<My remote>
vs. My Local <My local>-<My
local>
Send <packet>
Recv <packet>
Recv <Main or Aggressive>
Mode request from <IP>
Send <Main or Aggressive>
Mode request to <IP>
Invalid IP <Peer local> /
<Peer local>
236
DESCRIPTION
The IKE process for a new connection failed because the limit
of simultaneous phase 2 SAs has been reached.
Phase 2 Quick Mode has started.
The connection failed during IKE phase 2 because the router
and the peer's Local/Remote Addresses don't match.
The connection failed during IKE phase 2 because the router
and the peer's Local/Remote Addresses don't match.
The router retransmitted the last packet sent because there
was no response from the peer.
An Ethernet error stopped the router from sending IKE
packets.
An SA was deleted because there were too many errors.
The phase 1 IKE SA process has been completed.
The router received multiple requests from the same peer
while still processing the first IKE packet from the peer.
the connection, but the IKE process has not finished yet.
Phase 1 or phase 2 parameters don't match. Please check all
protocols / settings. Ex. One device being configured for
3DES and the other being configured for DES causes the
connection to fail.
The security gateway is set to "0.0.0.0" and the router used
the peer's "Local Address" as the router's "Remote Address".
This information conflicted with static rule #d; thus the
connection is not allowed.
The router couldn't resolve the IP address from the domain
name that was used for the secure gateway address.
The displayed ID information did not match between the two
ends of the connection.
The displayed ID information did not match between the two
ends of the connection.
The displayed ID information did not match between the two
ends of the connection.
A packet was sent.
IKE uses ISAKMP to transmit data. Each ISAKMP packet
contains many different types of payloads. All of them show in
the LOG. Refer to RFC2408 – ISAKMP for a list of all ISAKMP
payload types.
The router received an IKE negotiation request from the peer
address specified.
The router started negotiation with the peer.
The peer's "Local IP Address" is invalid.
Chapter 18 Logs