ZyXEL Communications P-660HW-T - V2 User Manual page 237

Table 101 IKE Logs (continued)
LOG MESSAGE
Remote IP <Remote IP> /
<Remote IP> conflicts
Phase 1 ID type mismatch
Phase 1 ID content mismatch
No known phase 1 ID type
found
ID type mismatch. Local /
Peer: <Local ID type/Peer ID
type>
ID content mismatch
Configured Peer ID Content:
<Configured Peer ID Content>
Incoming ID Content:
<Incoming Peer ID Content>
Unsupported local ID Type:
<%d>
Build Phase 1 ID
Adjust TCP MSS to%d
Rule <%d> input idle time
out, disconnect
XAUTH succeed! Username:
<Username>
XAUTH fail! Username:
<Username>
Rule[%d] Phase 1 negotiation
mode mismatch
Rule [%d] Phase 1 encryption
algorithm mismatch
Rule [%d] Phase 1
authentication algorithm
mismatch
Rule [%d] Phase 1
authentication method
mismatch
Rule [%d] Phase 1 key group
mismatch
Rule [%d] Phase 2 protocol
mismatch
Rule [%d] Phase 2 encryption
algorithm mismatch
Chapter 18 Logs
DESCRIPTION
The security gateway is set to "0.0.0.0" and the router used
the peer's "Local Address" as the router's "Remote Address".
This information conflicted with static rule #d; thus the
connection is not allowed.
This router's "Peer ID Type" is different from the peer IPSec
router's "Local ID Type".
This router's "Peer ID Content" is different from the peer
IPSec router's "Local ID Content".
The router could not find a known phase 1 ID in the
connection attempt.
The phase 1 ID types do not match.
The phase 1 ID contents do not match.
The phase 1 ID contents do not match and the configured
"Peer ID Content" is displayed.
The phase 1 ID contents do not match and the incoming
packet's ID content is displayed.
The phase 1 ID type is not supported by the router.
The router has started to build the phase 1 ID.
The router automatically changed the TCP Maximum
Segment Size value after establishing a tunnel.
The tunnel for the listed rule was dropped because there was
no inbound traffic within the idle timeout period.
The router used extended authentication to authenticate the
listed username.
The router was not able to use extended authentication to
authenticate the listed username.
The listed rule's IKE phase 1 negotiation mode did not match
between the router and the peer.
The listed rule's IKE phase 1 encryption algorithm did not
match between the router and the peer.
The listed rule's IKE phase 1 authentication algorithm did not
match between the router and the peer.
The listed rule's IKE phase 1 authentication method did not
match between the router and the peer.
The listed rule's IKE phase 1 key group did not match
between the router and the peer.
The listed rule's IKE phase 2 protocol did not match between
the router and the peer.
The listed rule's IKE phase 2 encryption algorithm did not
match between the router and the peer.
P-660HW-T v2 User's Guide
237