Rpvc Arp Agingtime Show Command; Rpvc Arp Show Command; Rpvc Arp Flush Command - ZyXEL Communications IES-22A User Manual

where
<sec>
This command configures how long the device stores the IP addresses of CPE devices using
2684 routed mode in the Address Resolution Protocol table.
The following example sets the device to store the IP addresses 2684 routed mode gateways in
the Address Resolution Protocol table for 500 seconds.
ras> shdsl rpvc arp agingtime set 500

54.5.12 RPVC ARP Agingtime Show Command

Syntax:
ras> shdsl rpvc arp agingtime show
This command displays how long the device stores the IP addresses of 2684 routed mode
gateways in the Address Resolution Protocol table.
The following is an example.
ras> shdsl rpvc arp agingtime show
rpvc aging time (sec): 600

54.5.13 RPVC ARP Show Command

Syntax:
ras> shdsl rpvc arp show
This command
gateways in the Address Resolution Protocol table.
The following is an example.
ras> shdsl rpvc arp show
gateway ip
---------------
192.168.10.102

54.5.14 RPVC ARP Flush Command

Syntax:
ras> shdsl rpvc arp flush
This command
Resolution Protocol table.
IES-708-22A User's Guide
The number of seconds (10~10000) the device is to keep the
=
Address Resolution Protocol table's entries of IP addresses of
2684 routed mode gateways. Use 0 to disable the aging time.
displays how long the device stores the IP addresses of 2684 routed mode
vid mac
---- -----------------
1 00:0d:9d:d9:43:3b
clears the IP addresses of 2684 routed mode gateways from the Address
Chapter 54 Virtual Channel Management
361