C
H A P T E R
This chapter describes some of the commands that allow you to configure and monitor the
DSL ports.
53.1 DSL Port Commands
Use these commands to configure the DSL ports. See
information on DSL and SHDSL.
53.1.1 DSL Port Show Command
Syntax:
ras> shdsl show [portlist]
where
[portlist]
This command shows the activation status, DSL mode, maximum upstream and downstream
rate settings, and DSL profile of each DSL port. It also provides subscriber information for the
port.
The following example displays information on DSL port 1.
ras> shdsl show 1
port enable mode min/max rate
---- ------ ---- ------------- ----- -------------------------------
1
V
Subscriber Info:
port name
---- -------------------------------- ----------------
1 -
53.1.2 DSL Port Enable Command
Syntax:
ras> shdsl enable <portlist>
IES-708-22A User's Guide
DSL Commands
You can specify a single DSL port <1>, all DSL ports <*> or a
=
list of DSL ports <1,3,5>. You can also include a range of ports
<1,5,6~8>.
pam
stur
192/
2304 auto
Chapter 13 on page 103
profile
DEFVAL
tel
-
53
for background
329