Table of Contents
Advertisement
To change the belt on the scoring blade
motor:
1.
disconnect the saw from the power
source!
2.
Move the blade tilt to 0˚ (blade 90˚ to table),
and raise the main blade and scoring blade
set up as far as they will go.
3.
open the motor cabinet door.
4.
push the scoring blade motor and remove
the flat belt.
5.
place the flat belt on the scoring blade arbor
as shown in figure 89, lift the scoring motor,
and slide the flat belt over the scoring motor
pulley.
scoring
Blade
Arbor
figure 89. replacing the scoring motor belt.
6.
Close and secure the motor cabinet door.
blade Tilt
the blade tilt is calibrated at the factory, but can
be adjusted if it changes during the life of the
machine.
To calibrate the blade tilt:
1.
disconnect the saw from the power
source!
g0451 14" sliding table saw
2.
Move the blade tilt to 90˚ according to the
gauge, and raise the main blade as far as it
will go.
3.
place a machinist's square between the
teeth on the blade and on the table surface
and inspect for gaps between the blade and
the square.
4.
if a gap exists at either the top or bottom
of the square, loosen the 90˚ tilt stop bolt
shown in figure 90.
Flat
Belt
scoring
Motor
5.
turn the handwheel until the blade and
square are flush from top to bottom.
6.
snug the adjustment screw against the under-
side of the table and tighten the lock nut.
7.
recheck the blade with the square to ensure
the screw has not been over-tightened.
8.
Adjust the blade angle until you hit the 45°
positive stop. Check the bevel with an adjust-
able square set to 45°.
9.
if variations exist, adjust the 45˚ tilt stop
bolt (figure 90) until the blade and square
match.
10. tighten the lock nut and recheck the bevel by
adjusting the blade back to 90°, then back to
45°.
90˚ tilt
stop Bolt
45˚ tilt stop Bolt
(hidden behind
the shaft)
figure 90. Blade tilt stop bolts.
-49-
Advertisement
Table of Contents
