Table of Contents
Advertisement
SecTiOn 7: Service
always
power to the machine
before performing ser-
vice adjustments. failure
to do this may result in
serious personal injury.
about Service
this section is designed to help the operator with
adjustments that were made at the factory and
that might also need to be made during the life of
the machine.
this section is provided for your convenience—
it is not a substitute for the grizzly service
department. if any adjustments arise that are not
described in this manual, then feel free to call the
grizzly service department at (570) 546-9663.
similarly, if you are unsure of how to perform
any procedure in this section, the grizzly service
department will be happy to guide you through
the procedures or help in any other way.
-48-
disconnect
To change the v-belt on the main motor:
1.
2.
3.
4.
5.
6.
7.
replacing belts
disconnect the saw from the power
source!
Move the blade tilt to 0˚ (blade 90˚ to table),
and raise the main blade and scoring blade
set up as far as they will go.
open the motor cabinet door.
loosen the tension bolt (figure 88) and pivot
the motor up to remove the v-belts. note—
You may need to use a hydraulic bottle jack
to lift the motor.
figure 88. v-belt tension bolt.
remove the old v-belts and replace them
with new belts. note—Always replace all of
the belts as a matched set.
tighten the tension bolt until the belts deflect
between a
⁄
" and a
⁄
" when pressed firmly
1
1
4
2
in the center of each v-belt.
Close and secure the motor cabinet door.
g0451 14" sliding table saw
Advertisement
Table of Contents
