Grizzly G0451 Instruction Manual page 32

35. Move the blade guard back to its original
position, and move the sliding table back to
center.
36. place the end washer (figure 45) on the
end of the round rail and secure it with the
M8-1.25 x 16 cap screw and 8mm lock wash-
er.
end Washer
figure 45. end washer on round rail.
37. thread the M12-1.75 x 55 adjustable handle,
with a 12mm flat washer, through the cross-
cut table and into a M12-1.75 t-nut as shown
in figure 46.
figure 46. installing the adjustable handle.
-30-
38. With the help of an assistant, place the cross-
cut table on the pivot pin of the swing arm
and slide the t-nut into the t-slot in the slid-
ing table (see figure 47).
sliding t-nut
into t-slot
figure 47. installing the crosscut table.
39. slide two M8-1.25 t-nuts into the crosscut
table brace. Align the t-nuts in the crosscut
table brace with the holes in the crosscut
table, and thread the two M8-1.25 x 50
knobs, with two 8mm flat washers, into the
t-nuts as shown in figure 48.
Crosscut
table Brace
figure 48. installing the crosscut table brace.
g0451 14" sliding table saw