Grizzly G0451 Instruction Manual page 27

7.
Attach the support brace and dust collection
hose support to the table with four M10-1.5 x
30 cap screws, four 10mm lock washers, four
10mm flat washers, and two M10-1.5 hex
nuts, as shown in figure 27.
dust Collection
hose support
support Brace
figure 27. support brace and dust collection
hose support installation.
8. use a straightedge, as shown in figure 28,
to make sure the extension table is even with
the cast iron table. use the set screws under
the extension tables to level the top surfaces,
then tighten all the mounting cap screws.
figure 28. Checking with a straightedge.
g0451 14" sliding table saw
9.
thread an M10-1.5 hex nut all the way onto
two M10-1.5 x 20 cap screws, then install the
cap screws where shown in figure 29 to hold
the small extension table level. tighten the
hex nuts against the table support to lock the
cap screws in place.
figure 29. small extension table support cap
screws (table removed for photo clarity).
10. Mount the scale bar to the cast iron table and
large extension table, making sure it is even
with the top of the tables. use the three M6-1
x 25 hex bolts, three 6mm flat washers, three
6mm lock washers, and three M6-1 hex nuts,
as shown in figure 30, to mount it. (the top
of the hex bolts slide into the scale bar.)
figure 30. Attaching the scale bar.
-25-