Grizzly G0451 Instruction Manual page 44

crosscutting full size panels:
1.
install the crosscut fence in the forward
mounting points shown in figure 74 and lock
it in place.
2.
Check to make sure the fence is at 90˚ and
adjust it as described in "squaring Crosscut
Fence to Blade" on page 52 if necessary.
Forward
Mounting points
figure 74. Crosscut fence mounting points.
3. set either flip stop to the desired width-of-cut.
note—Extend the crosscut fence slide if the
workpiece is more than 74".
4.
load the workpiece onto the table saw. the
set up should look similar to figure 71.
5.
once all the necessary safety precautions
have been taken, perform the cutting opera-
tion.
crosscutting smaller panels:
1. install the crosscut fence in the rear mount-
ing points shown in figure 74 and lock it in
place.
2.
Check to make sure the fence is at 90˚ and
adjust it as described in "squaring Crosscut
Fence to Blade" on page 52 if necessary.
3.
set either flip stop to the desired width-of-cut.
note—Extend the crosscut fence slide if the
workpiece is more than 74".
-42-
rear Mounting
points
4. load the workpiece onto the table saw. the
set up should look similar to figure 72.
5. once all the necessary safety precautions
have been taken, perform the cutting opera-
tion.
crosscutting using the rip fence as a cut-off
gauge:
1. install the crosscut fence in the rear mount-
ing points shown in figure 74 and lock it in
place.
2.
Check to make sure the fence is at 90˚ and
adjust it as described in "squaring Crosscut
Fence to Blade" on page 52 if necessary.
3. position the rip fence for the desired width.
4. load the workpiece onto the table saw. the
set up should look similar to figure 73.
5. slide the leading end of the rip fence behind
the back edge of the blade as shown in
figure 75.
figure 75. Correct rip fence position when using
it as a cut-off gauge.
6. take all the necessary safety precautions,
then perform the cutting operation.
g0451 14" sliding table saw