Table of Contents
Advertisement
17. install the flat belt on the scoring motor and
arbor pulley as shown in figure 35.
note: The scoring motor adjusts by lifting it
up. The weight of the scoring motor dictates
the correct belt tension.
Flat Belt
figure 35. Flat belt installed on scoring motor
and arbor pulley (table removed for clarity).
18. slide the table all the way forward to access
the blade arbor and pull open the blade guard
(see figure 36).
Main Blade
Arbor
figure 36. Main blade arbor components.
g0451 14" sliding table saw
19. use the arbor wrench to remove the arbor
nut and arbor flange. note: The arbor nut
has left hand threads and loosens by turning
clockwise.
before proceeding with the next steps, wear
gloves to protect your hands when handling
and installing the blade.
20. slide the blade over the arbor with the teeth
facing the right side of the saw, and re-install
the arbor flange and the arbor nut. the main
blade arbor nut has left-hand threads and
tightens counterclockwise. hold the arbor
with one arbor wrench and tighten the nut
with the
other arbor wrench as shown in
figure 37.
figure 37. installing the main blade.
21. slide the rip fence over until it just touches
the blade.
22. Adjust the mounting position of the round rail
until the rip fence evenly touches the entire
width of the blade from front to back.
note: To adjust the mounting position of the
round rail, use the hex nuts (on the round rail
studs) that are on both sides of the tables.
-27-
Advertisement
Table of Contents
