Table of Contents
Advertisement
40. install the components shown in figure 49
on the crosscut fence.
Flip stops
t-Bolt
t-nut, Fiber Washer & Center stud
figure 49. Crosscut fence assembly.
41. position the center stud and the t-bolt over
the placement holes shown in figure 50,
then tighten the center stud.
Center stud
placement
figure 50. Crosscut fence placement.
42. thread the M8-1.25 knob with an 8mm flat
washer onto the t-bolt to secure the crosscut
fence.
43. slide the blade guard/dust hood over the
riving knife, and attach it with an M8-1.25 x
40 button head cap screw and an 8mm flat
washer.
44. (optional) if needed, slide the edge shoe and
hold down clamp into the table t-slot, and
tighten the respective knob/handle. position
where necessary. (the front cover picture
shows these items installed.)
g0451 14" sliding table saw
M8-1.25 X 25
KnoB
t-nut, Block,
lock Washer,
Cap screw
t-Bolt
placement
dO nOT operate the Model g0493 without an
adequate dust collection system. This saw
creates substantial amounts of wood dust
while operating. failure to use a dust collec-
tion system can result in short and long-term
respiratory illness.
required cfM at 5" dust port:
required cfM at 2
⁄
" dust port:
1
2
Do not confuse this CFM recommendation with
the rating of the dust collector. To determine
the CFM at the dust port, you must consider
these variables: (1) CFM rating of the dust col-
lector, (2) hose type and length between the
dust collector and the machine, (3) number
of branches or wyes, and (4) amount of other
open lines throughout the system. Explaining
how to calculate these variables is beyond the
scope of this manual. Consult an expert or pur-
chase a good dust collection "how-to" book.
45. secure a 5" dust hose to the dust port located
under the saw table (figure 51).
figure 51. 5" dust port location.
625 cfM
150 cfM
-31-
Advertisement
Table of Contents
