Power Connection - Grizzly G0451 Instruction Manual

46. Attach the blade guard/dust hood to the riv-
ing knife with the M8-1.25 x 40 button head
cap screw and 8mm flat washer. (the blade
guard/dust hood Must be installed.)
47. Attach a 2½" dust hose to the dust port, as
shown in figure 52.
figure 52. 2½" dust port location.
48. run the 2½" hose over the hose support, as
shown in figure 53.
figure 53. dust hose support in use.
49. run ground wires through the dust hoses and
attach the wires to the machine to protect
against static electricity.
-32-

power connection

Before connecting the saw to power, read through
SecTiOn 2: circuiT reQuireMenTS to
check that your setup follows the safety and circuit
requirements for this machine.
To connect the saw to the power source:
1.
open the power connection box shown in
figure 54.
power Connection Box
figure 54. power connection box.
2. Connect the power wires to the terminals
shown in figure 55, tighten the strain relief
so the wires can't be pulled from the termi-
nals, then close the power connection box.
note: When using a phase converter, con-
nect the manufactured power leg to the S
terminal to prevent damage (see Page 16).
r s t
figure 55. Main terminal box.
g0451 14" sliding table saw
ground