Grizzly G0451 Instruction Manual page 28

11. Make sure each of the four rail studs are pre-
assembled with a 12mm flat washer and two
M12-1.75 hex nuts, then thread them into the
round rail, as shown in figure 31.
figure 31. installing studs with hardware into the
round rail.
12. insert the studs into the tables as shown in
figure 32. put a 12mm flat washer, 12mm
lock washer and a M12-1.75 hex nut on the
end of each stud to hold the round rail on
the tables. do not tighten the hex nuts at this
time.
figure 32. installing the round rail.
-26-
13. slide the rip fence body onto the round rail.
thread the lock handles M10-1.5 x 12 and
knob M10-1.5 x 70 into the rip fence body,
where shown in figure 33.
lock handles
M10-1.5 x 12
figure 33. rip fence handles.
14. slide the aluminum rip fence onto the clamp-
ing plate as shown in figure 34, and lock it
with the fence lock handle.
Clamping
plate
figure 34. installing the rip fence.
15.
open the motor compartment and
the red shipping braces from both motors,
then re-install the shipping brace fasteners
back into the holes from which they came.
16. Move the blade arbor tilt to 0˚ and raise it as
far as it will go.
g0451 14" sliding table saw
Knob
M10-1.5 x 70
Fence lock
handle
remove