Table of Contents
Advertisement
23. Check if the metal part of the rip fence rests
on the surface of the table.
note: The rip fence body will scratch the
table surface if the ride height is not adjusted
correctly. Only the roller should touch the
table surface.
— if the rip fence body does not rest on the
table, then the fence is correctly adjusted.
— if the rip fence body does rest on the table,
remove the rip fence and turn it upside
down. loosen the set screw shown in
figure 38 and rotate the hex bolt to raise
the roller. tighten the set screw to lock the
ride height and recheck how the rip fence
rests on the table.
roller
figure 38. rip fence height adjustment.
24. Check the height of the rip fence rail by slid-
ing the rip fence along the rail and comparing
the gap between the rip fence body and the
tables.
25. Adjust the height of the rip fence rail, then
tighten all of the hex nuts to secure the round
rail in place.
-28-
set screw
hex Bolt
26. loosen the riving knife center bolt, slide the
riving knife over the bolt as shown in figure
39, and slightly tighten.
figure 39. installing the riving knife.
27. position the riving knife about 3mm or
away from the nearest carbide tooth on the
main blade. note: For a quick gauge, use the
3mm hex wrench to find the correct spacing
between the blade and the riving knife, as
shown in figure 40.
figure 40. Adjusting the riving knife.
28. tighten the center bolt to secure the riving
knife in position.
g0451 14" sliding table saw
riving Knife
⁄
"
1
8
Advertisement
Table of Contents
