7.
press the blade on buttons. nothing should
happen.
—if the stop switch is working correctly, reset
the switch.
8.
repeat Steps 6–7 with the #2 emergency
stop switch.
9.
Make sure both emergency stop buttons are
reset before continuing.
10. open the cabinet door at the rear of the
machine. this opens the limit switch at the
door.
11. press the blade on buttons. nothing should
happen.
12. Close and latch the cabinet door.
-34-
13. turn the key switch off and disConneCt
sAW FroM poWer!
14. Move the sliding table all the way forward,
then open the orange blade guard. this
opens the blade guard limit switch.
15. Connect the saw to the power source and
turn the power switch key on.
16. (during this step, be prepared to immediately
press the #1 emergency stop switch if the
blades start operating.) press the blade on
buttons. nothing should happen.
17. turn the key switch off and disConneCt
sAW FroM poWer!
18. Close the orange blade guard and move
the sliding table back to the center of the
machine.
g0451 14" sliding table saw