Enabling Oam Remote Loopback - 3Com S7906E Configuration Manual

To do...
Configure the errored frame
seconds event triggering
threshold
Make sure the errored frame seconds triggering threshold is less than the errored frame seconds
detection interval. Otherwise, no errored frame seconds event can be generated.

Enabling OAM Remote Loopback

After enabling OAM remote loopback on a port, you can send loopback frames from the port to a remote
port and then observe how many of these loopback frames are returned. In this way, you can calculate
the packet loss ratio on the link, thus evaluating the link performance.
Follow these steps to enable Ethernet OAM remote loopback:
To do...
Enter system view
Enter Ethernet port view
Enable Ethernet OAM remote
loopback
Use the command...
oam errored-frame-seconds
threshold threshold-value
Use the command...
System-view
interface interface-type
interface-number
oam loopback
1-8
Remarks
Optional
1 by default
Remarks
—
—
Required
Disabled by default.