Configuring Member Ports For A Smart Link Group; Configuring Role Preemption For A Smart Link Group - 3Com S7906E Configuration Manual

Configuring Member Ports for a Smart Link Group

You can configure member ports for a smart link group either in smart link group view or in interface view.
The configurations made in these two views have the same effect.
In smart link group view
Follow these steps to configure member ports for a smart link group in smart link group view:
Enter system view
Create a smart link group and enter
smart link group view
Configure member ports for a smart link
group
In interface view
Follow these steps to configure member ports for a smart link group in interface view:
Enter system view
Enter Ethernet interface view or layer 2
aggregate interface view
Configure member ports for a smart link
group

Configuring Role Preemption for a Smart Link Group

Follow these steps to configure role preemption for a smart link group:
Enter system view
Create a smart link group and enter
smart link group view
Enable role preemption
Configure the preemption delay
The preemption delay configuration takes effect only after role preemption is enabled.
To do...
To do...
To do...
Use the command...
system-view
smart-link group group-id
port interface-type
interface-number { master |
slave }
Use the command...
system-view
interface interface-type
interface-number
port smart-link group group-id
{ master | slave }
Use the command...
system-view
smart-link group group-id
preemption mode role
preemption delay delay-time
1-7
Remarks
—
—
Required
Remarks
—
—
Required
Remarks
—
—
Required
Disabled by default.
Optional
1 second by default