One-Step Patch Uninstallation; Step-By-Step Patch Uninstallation; Step-By-Step Patch Uninstallation Task List; Stop Running Patches - 3Com S7906E Configuration Manual

One-Step Patch Uninstallation

You can use the undo patch install command to uninstall all patches from all the cards and OAM CPU.
The patches then turn to the IDLE state. This equals the execution of the commands patch deactive
and patch delete on each card and OAM CPU.
Follow these steps to uninstall the patches in one step:
To do...
Enter system view
Uninstall the patches

Step-by-Step Patch Uninstallation

Step-by-Step Patch Uninstallation Task List

Stop Running Patches

Deleting Patches

Stop Running Patches
After you stop running a patch, the patch state becomes DEACTIVE, and the system runs in the way
before it is installed with the patch.
Follow the steps below to stop running patches: (distributed device)
To do...
Enter system view
Stop running the specified
patches
Follow the steps below to stop running patches: (distributed IRF device)
To do...
Enter system view
Stop running the specified
patches
Deleting Patches
Deleting patches only removes the patches from the memory patch area, and does not delete them
from the storage medium. The patches turn to IDLE state after this operation. After a patch is deleted,
the system runs in the way before it is installed with the patch.
Follow the steps below to delete patches: (distributed device)
Use the command...
system-view
undo patch install
Task
Use the command...
system-view
patch deactive patch-number
slot slot-number
Use the command...
system-view
patch deactive patch-number
chassis chassis-number slot
slot-number
1-9
—
Required
Remarks
Required
Required
—
Required
—
Required
Remarks
Remarks
Remarks