Modifying Access Rights; Enabling And Disabling Remote Access - 3Com SuperStack II Manual

150 C 4: W
HAPTER ORKING
Modifying Access
Rights
Enabling and
Disabling Remote
Access
W C L
ITH THE OMMAND INE
You can modify access rights for the access levels in the stack using the
command on the System/Security/Access menu.
modify
To modify the access rights for the stack:
1 From the Top-level menu, enter:
system security access modify
The following prompt is displayed:
Enter access level (monitor,manager,security):
2 Enter the access level to be modified.
The following prompt is displayed:
Enter new value for SNMP (enable,disable) [enable]:
3 Enter if the access level allows SNMP management, or
enable
it does not.
The following prompt is displayed:
Enter new value for console (enable,disable) [enable]:
4 Enter if the access level allows management through a console
enable
port of the stack, or
The following prompt is displayed:
Enter new value for telnet (enable,disable) [enable]:
5 Enter if the access level allows telnet management, or
enable
it does not.
The following prompt is displayed:
Enter new value for web (enable,disable) [enable]:
6 Enter if the access level allows web management, or
enable
does not.
As a basic security measure, you can enable or disable remote access to
the management software of the stack:
When remote access is enabled, you can access the management
software using all management methods.
When remote access is disabled:
Users cannot access the stack over the network using the
command line interface.
I
NTERFACE
if it does not.
disable
if
disable
if
disable
if it
disable