Manually Configuring Switchover Between The Amb And Smb; Displaying And Maintaining Dual-Srpu System - 3Com S7906E Configuration Manual

To do...
Enter system view
Manually restart the SMB
After the SMB has restarted, the AMB will perform initial synchronization on the SMB. During this
process, the system does not respond to your input. After the initial synchronization is completed, you
can execute all the configuration commands on the AMB and the AMB and SMB will keep a real-time
synchronization process, meaning your configuration on the AMB will be copied to the SMB to ensure
the consistency of the current configuration of the AMB and SMB.

Manually Configuring Switchover Between the AMB and SMB

To do...
Enter system view
Enable the manual switchover
between the AMB and SMB
Manually configure switchover
between the AMB and SMB
The original AMB will be restarted if an AMB and SMB switchover is performed. Therefore, ensure the
consistency of the software version of the AMB and SMB before performing an AMB and SMB
switchover. By default, if the versions of the AMB and SMB are not consistent, the original AMB cannot
be restarted; to perform an AMB and SMB switchover in case that their versions are not consistent,
configure to ignore version check of the SMB.

Displaying and Maintaining Dual-SRPU System

To do...
Display the switchover state
(independent mode)
Display the switchover state
(IRF mode)
Use the command...
system-view
slave restart
Use the command...
system-view
slave switchover { disable |
enable }
slave switchover
Use the command...
display switchover state
[ slot slot-number ]
display switchover state
[ chassis chassis-number slot
slot-number ]
1-3
Remarks
—
Required
Remarks
—
Optional
Enabled by default
Required
Remarks
Available in any view