Outputting System Information To The Trap Buffer - 3Com S7906E Configuration Manual

To do...
Specify a log host and
configure the parameters when
system information is output to
the log host
Configure the output rules of
the system information
Specify the source IP address
for the log information
Configure the format of the time
stamp for system information
output to the log host

Outputting System Information to the Trap Buffer

The trap buffer receives the trap information only, and discards the log and debugging information even
if you have configured to output them to the trap buffer.
To do...
Enter system view
Enable information center
Name the channel with a
specified channel number
Use the command...
info-center loghost host-ip
[ port port-number ] [ channel
{ channel-number |
channel-name } | facility
local-number ] *
info-center source
{ module-name | default }
channel { channel-number |
channel-name } [ debug { level
severity | state state } * | log
{ level severity | state state } * |
trap { level severity | state
state } * ] *
info-center loghost source
interface-type interface-number
info-center timestamp
loghost { date | no-year-date |
none }
Use the command...
system-view
info-center enable
info-center channel
channel-number name
channel-name
1-10
Remarks
Required
By default, the system does not
output information to a log host.
If you specify to output system
information to a log host, the
system uses channel 2
(loghost) by default.
The value of the port-number
argument should be the same
as the value configured on the
log host, otherwise, the log host
cannot receive system
information.
Optional
Refer toDefault Output Rules of
System Information.
Optional
By default, the source interface
is determined by the matched
route, and the primary IP
address of this interface is the
source IP address of the log
information.
Optional
date by default.
Remarks
—
Optional
Enabled by default
Optional
Refer to Table 1-2 for default
channel names.