Configuring Irf; Setting A Member Id For A Device - 3Com S7906E Configuration Manual

When the switch operates in standalone mode (that is, IRF is not enabled on the switch), the OLT
function can operate normally; when the switch operates in IRF mode (that is, IRF in enabled on
the switch), the OLT cards cannot start.
For introduction to the OLT function, refer to EPON-OLT Configuration in the Access Volume.
If the device is operating in standalone mode and will be added into an IRF, you must configure its
operating mode as the IRF mode, create IRF ports on it, perform other necessary configurations,
connect it with the IRF member(s) physically, and then it will join the IRF.
Follow these steps to switch the operating mode of the device:
To do...
Enter system view
Switch the operating mode of
the device to IRF mode
The device will reboot automatically as soon as you confirm the operation of switching the operating
mode.

Configuring IRF

Setting a Member ID for a Device

The member ID of a device defaults to 1. Before an IRF is formed, you need to manually number the two
devices respectively to avoid member ID collision.
You are recommended to set the member ID for a newly added device in the following way:
1) Plan the member IDs in advance. You can view the member IDs of an IRF, and find out an unused
ID for the new device.
2) If the device is already an IRF member, plug out the IRF cables.
3) Log in to the device to be added into the IRF, and change its member ID to the unused ID found out
in step 1.
4) Configure the IRF port(s) and other optional parameters.
5) Save the current configuration. Power off the device, connect the device with IRF cables and power
it on.
Follow these steps to set a member ID for a device:
To do...
Enter system view
Set a member ID for a device
Use the command...
system-view
chassis convert mode irf
Use the command...
system-view
irf member member-id renumber
new-member-id
1-10
Remarks
—
Required
By default, the device
operates in standalone mode.
Remarks
—
Optional
The member ID of a device
defaults to 1