Enabling the Sending of Flush Messages
Follow these steps to enable the sending of flush messages:
Enter system view
Create a smart link group and enter
smart link group view
Enable flush update in the specified
control VLAN
The control VLAN configured for a smart link group must be different from that configured for any
other smart link group.
Make sure that the configured control VLAN already exists, and assign the smart link group
member ports to the control VLAN.
Do not remove the control VLAN. Otherwise, flush messages cannot be sent properly.
Configuring the Collaboration Between Smart Link and CC of CFD
Follow these steps to configure the collaboration between Smart Link and the CC function of CFD on a
smart link member port:
Enter system view
Enter Ethernet interface view
Configure the collaboration between
Smart Link and the CC function of CFD
on the port
When configuring the collaboration between Smart Link and the CC function of CFD on a smart link
member port, make sure that the control VLAN of the smart link group to which the port belongs
matches the detection VLAN of the CC function of CFD.
To do...
To do...
Use the command...
system-view
smart-link group group-id
flush enable [ control-vlan
vlan-id ]
Use the command...
system-view
interface interface-type
interface-number
port smart-link group group-id
track cfd cc
1-8
Remarks
—
Required
Optional
By default, flush
update is enabled,
and VLAN 1 is the
control VLAN.
Remarks
—
—
Optional
By default, the
collaboration between
Smart Link and the
CC function of CFD is
not configured.