Functions of Digital I/O Units
4-4
Functions of Digital I/O Units
4-4-1
I/O Power Supply Monitor
Function Overview
48
(2) When 2-pin terminals are used next to each other, insert them facing ver-
tically as shown in the following figure, so that the terminal insulating cov-
ers do not interfere with each other.
Crimp the pin terminals on the sides that align with wide sides of the in-
sulating cover, as shown in the following figure.
Use the following screwdriver or an equivalent to remove the wires.
Recommended Screwdriver
Model
SZF1
Phoenix Contact
Side view
Front view
0.6 mm
3.5 mm
This function is used to detect whether the I/O power is ON.
When the I/O power supply is turned OFF, the Basic Unit I/O Power Supply
Status Flag or Expansion Unit I/O Power Supply Status Flag in the Status
Area is turned ON. (BIt 4 of the Communications Unit's Status Flags will be
ON.)
Maker
Section 4-4