Page 1
Input NPN/PNP 110 VDC max., 240 VAC max. G70A-ZIM16-5 (See note) Note: Each relay to be mounted must incorporate a coil that has proper specifications within the maximum rated voltage range. ■ Suitable Relay/SSR Classification I/O Block Base PCB Relay...
Diode (2 A, withstand inverse voltage: 40 V) connection Tightening torque 0.59 N·m Note: Use a DC relay with a built-in diode because a DC relay without a built-in diode does not absorb any coil surge. ■ Relay (G2R-1-S, G2R-1-SN) Coil Ratings Rated voltage...
Page 3
–20% (DC coil resistance). 2. LEDs are used for the built-in operation indicator. For models equipped with these indications, the VAC rated current must be increased by approximately 1 mA; the VDC rated current, by approximately 4 mA. 3. Operating characteristics are measured at a coil temperature of 23°C.
100 MΩ min. between input and output Dielectric strength 4,000 VAC, 50/60 Hz for 1 min between input and output Vibration resistance 10 to 55 to 10 Hz, 0.75-mm single amplitude (1.5-mm double amplitude) Shock resistance 1,000 m/s Ambient temperature Operating: –30°C to 80°C (with no icing)
Page 5
■ When Mounted to a G3RZ Load Current vs. Ambient Inrush Current Resistivity Temperature Non-repetitive (Keep the inrush current to half the rated value if it occurs repetitively.) G3RZ-201SLN G3RZ-201SLN −30 −20 30 50 300 500 1,000 3,000 5,000 10,000 55 60 Ambient temperature (°C)
Page 6
Dimensions Note: All units are in millimeters unless otherwise indicated. G70A-ZOC16 (Output) 35.5−8.2 28.6 9.2 19.6 20.7 M3.5 34.2 48.7 G70A-ZIM16 (Input) 48.7 10.2 35.5−8.2 9.2 19.6 M3.5 20.7 34.2 G70A I/O Block Base...
Page 8
When mounting to a G3R-OA@ or G3RZ-201SLN, pins 11 to 14 are output terminals. When mounting to a G3R-OD@, pin 14 is a plus terminal and pin 11 is a minus terminal. When mounting to G3RZ-201SLN, there is no polarity.