Omron GRT1 - 11-2007 Operation Manual page 128

Analog Input Units
Setting Procedure (Example: DeviceNet Configurator)
1,2,3...
■ When the Default Settings Are Used
When the Analog Input Unit's default settings are used, only the analog input
values are selected as I/O data and allocated in the two words (four bytes) of
the Master's Input Area, as shown in the following diagram.
15
Analog Input Value for Input 0
Analog Input Value for Input 1
■ Allocating Data (Example: DeviceNet Configurator)
Analog data is combined with other data such as Status Flags as shown
below, and allocated as I/O. By using the Setting Tool, it can be selected from
a pull-down list.
Example: Allocating Analog Data + Top/Valley Detection Timing Flags
15
Top Detection Timing Flag
The DeviceNet Configurator can be used as described below to allocate data.
1. In the Network Configuration Window for the Slice I/O Terminal, double-
click the icon of the Slice I/O Terminal that is to be set. Alternatively, right-
click the icon and select Parameters - Edit. The Edit Device Parameters
Window will be displayed.
2. Click the I/O Module Tab.
3. Click the Edit Button on the I/O Module Tab Page. The Edit Unit Parame-
ters Window will be displayed.
8 7
Analog Data for Input 0
Analog Data for Input 1
Valley Detection Timing Flag
Section 5-4
0
0
107