Table of Contents
Advertisement
Section 2
Installation
Removing Procedures
Removing procedures are as follows:
1.
Slide the Sensor Amplifier Unit to
remove it from the communication unit.
2.
Keep pressing the communication unit in direction A and lift it up in
direction B to remove.
Precautions for Replacing Units
The following parameters have been stored into the internal memory of the
communications unit. If the default value have been changed, these parameters must be
set again when replacing units.
• Number of connected Sensors
• Number of monitors for the detection level
E3X-DRT21-S
26
User's Manual
The order of steps 1 and 2 in the
installation method described above
must be followed correctly. Mounting
strength may decrease if the order is
not correct.
Keep pressing it in
direction A,
Order of step (1) to
NG as the order of
step (2)
step (2) to step (1)
A
in direction B
and lift up.
B
Advertisement
Table of Contents
