Cj1W-Od212 Transistor Output Unit (16 Points) - Omron CJ2 CPU UNIT User Manual

Appendices

CJ1W-OD212 Transistor Output Unit (16 Points)

Name
Model
Rated Voltage
Operating Load Voltage Range
Maximum Load Current
Maximum Inrush Current
Leakage Current
ON Response Time
OFF Response Time
Load Short-circuit Protection
Insulation Resistance
Dielectric Strength
Number of Circuits
Internal Current Consumption
External Power Supply
Weight
Circuit Configuration
Terminal Connections
*1 Terminal numbers A0 to A8 and B0 to B8 are used in this manual, but they are not printed on the
Unit.
A-40
16-point Transistor Output Unit with Terminal Block (Sourcing Outputs)
CJ1W-OD212
24 VDC
20.4 to 26.4 VDC
0.5 A/point, 5.0 A/Unit
0.1 mA max.
1.5 V max.
0.5 ms max.
1.0 ms max.
Detection current: 0.7 to 2.5 A
Automatic restart after error clearance. (Refer to page A-149.)
20 MΩ between the external terminals and the GR terminal (100 VDC)
1,000 VAC between the external terminals and the GR terminal for
1 minute at a leakage current of 10 mA max.
16 (16 points/common, 1 circuit)
5 VDC, 100 mA max.
20.4 to 26.4 VDC, 40 mA min.
120 g max.
Output indicator
ERR indicator
• When overcurrent is detected, the ERR indicator will light, and the corre-
sponding flag in the Basic I/O Unit Information Area (A050 to A069) will
turn ON.
*1
Signal Connec-
Signal
tor pin
name
name
OUT0
L A0
OUT1
B0 L
OUT2
L A1
OUT3
L
B1
OUT4
L A2
OUT5
B2 L
OUT6
L A3
OUT7
B3 L
OUT8
L A4
OUT9
B4 L
OUT10
L
A5
OUT11
B5 L
OUT12
L
A6
OUT13
B6 L
OUT14
L A7
OUT15
B7 L
0 V
A8
COM (+V)
B8
24 VDC
• When wiring, pay careful attention to the polarity of the external power
supply. The load may operate incorrectly if the polarity is reversed.
Signal
name
COM (+V)
OUT0
to
OUT15
0 V
CJ2 CPU Unit Hardware User's Manual