Creating Ties - Dxp 168 And 1616 Plus - Extron electronics DXP HD 4K PLUS User Manual

Creating Ties — DXP 168 and 1616 PLUS
This section provides the step-by-step procedure for creating ties on the DXP 1616 PLUS series. For the
examples used in the procedure, Input 5 is being tied to outputs 1, 2, and 3.
NOTE: This example assumes that there are no ties in the current configuration.
1. Press and release the Escape button.
Press the Escape button to
clear all selections.
CONTROL
ENTER PRESET VIEW
The button blinks
Figure 15. Clear all Selections
2. To select video and audio for the tie, press and release the Video and Audio buttons as necessary until both
the buttons light.
Green when video is selected
Off when video is deselected
Figure 16. Select Video and Audio
3. Press and release the desired Input button (Input 5 in the example below).
Press and release an input button.
The button lights amber.
1 2 3
9 10 11 12
Figure 17. Select an Input
4. Press and release the Output buttons to be tied to the selected Input button (Output buttons 2, 3, and 4 in
figure 18).
Press and release the desired Output buttons.
The buttons blink amber to indicate the
selected input is to be tied to these outputs.
1 2 3
9 10 11 12
Figure 18. Select the Outputs
NOTE: You can cancel the entire set of ties at this point by pressing and releasing the Escape button. The
Escape button blinks red once.
ESCAPE
once.
I/O
VIDEO AUDIO
Red when audio is selected
Off when audio is deselected
INPUTS
4 5 6 7 8
13 14 15 16
OUTPUTS
6
4 5 7 8
13 14 15 16
Blinking green
CONTROL
indicates the need
ENTER
PRESET VIEW ESCAPE
to con rm the change.
DXP HD 4K PLUS Series • Operation 25